USING YOUR ELECTRIC BLANKET
Controls
Note: On initial use it is recommended that the blanket be set on
setting ‘9’ for 30 minutes before sleeping on the bed and then
set to setting ‘1’ for continuous use. Preset on ‘9’ will assist in
drying out any moisture which has been accumulated in the
mattress.
Note: You may notice an odour when using the blanket for the
first time, due to the insulation material. This is harmless and
will subside quickly.
IMPORTANT
Setting 9 must ONLY be used for preheat up to a
maximum of 30 minutes. DO NOT sleep with setting 9.
If desired, 30 minutes before going to bed setting 9
can be selected to pre-heat the bed.
If blanket is used continuously all night, settings 1-3
are recommended as a maximum.
1. Slide ‘On’ to switch on the blanket.
2. Select either ‘Body’ or ‘Feet’ to heat different
areas of the blanket.
3. Adjust the temperature by selecting a heat setting
1-8.
4. Press the ‘timer’ button to set a timer for up to 12
hours.
8
To Next Page
Loading...