What to do if my Zanussi ZTAN28FW0 Refrigerator does not operate?
If your Zanussi Refrigerator isn't working, first ensure that it is switched on. Then, check that the mains plug is correctly connected to the mains socket. Finally, test the socket with another appliance to confirm there is voltage. If not, contact a qualified electrician.
Why is the temperature in my Zanussi ZTAN28FW0 Refrigerator too low/too high?
If the temperature in your Zanussi Refrigerator is too high or too low, first ensure that the temperature is set correctly. If the door is not closed correctly, refer to 'Closing the door' section. Ensure the food products' temperature is not too high, and avoid storing many food products at the same time.
Why is there too much condensed water on the rear wall of my Zanussi Refrigerator?
If there's too much condensed water on the rear wall of your Zanussi Refrigerator, it could be due to the door being opened too frequently or not being closed completely. Try to open the door only when necessary and ensure it's fully closed after each use. Also, make sure to wrap food in suitable packaging before storing it in the appliance.
What to do if water flows inside my Zanussi ZTAN28FW0 Refrigerator?
If water is flowing inside your Zanussi Refrigerator, it may be because food products are preventing water from flowing into the water collector. Ensure that food products do not touch the rear plate. Also, the water outlet may be clogged, so try cleaning it.
Why is water flowing on the floor from my Zanussi ZTAN28FW0 Refrigerator?
If water flows on the floor from your Zanussi Refrigerator, ensure the melting water outlet is attached to the evaporative tray above the compressor.
Why is there too much frost and ice in my Zanussi ZTAN28FW0 Refrigerator?
If there is too much frost and ice in your Zanussi Refrigerator, refer to 'Closing the door' section to ensure that the door is closed correctly. Also, refer to 'Closing the door' section to check if the gasket is deformed or dirty.
What to do if the lamp does not work in my Zanussi ZTAN28FW0 Refrigerator?
If the lamp in your Zanussi Refrigerator does not work, close and open the door to see if the lamp is in stand-by mode. If this does not work, contact the nearest Authorized Service Centre as the lamp may be defective.
Why does the compressor operate continually in my Zanussi Refrigerator?
If your Zanussi Refrigerator's compressor operates continually, it might be due to an incorrect temperature setting. Also, putting many food products in at the same time can cause this. Ensure food products cool to room temperature before storing. The door may not be closed correctly, so refer to 'Closing the door' section. Finally, check if the Super Freeze function is switched on, and refer to 'Super Freeze function' section.
Why doesn't the door open easily on my Zanussi ZTAN28FW0 Refrigerator?
If your Zanussi Refrigerator door doesn't open easily, it might be because you attempted to re-open the door immediately after closing it. Wait a few seconds between closing and re-opening the door.
What to do if the door is misaligned on my Zanussi ZTAN28FW0?
If your Zanussi Refrigerator door is misaligned, it's likely that the appliance is not levelled. Refer to the installation instructions for leveling guidance.
General| Type | Free Standing |
|---|---|
| Energy Rating | A+ |
| Color | White |
| Cooling System | Static |
| Energy efficiency class | A+ |
| Freezing capacity | 4 kg/24h |
| Climate class | SN-N-ST |
| Noise level | 39 dB |
| Number of Shelves | 3 |
| Number of Door Bins | 3 |
| Reversible Door | Yes |
| Defrost System | Manual |
| Width | 55 cm |
To Next Page
