Zanussi ZWH71246 - User Manual

69 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

User Manual for model

ZWH71246, ZWH71046

EN + ZH (Traditional)

This drawing contains confidential information and is the property of Aktiebolaget Electrolux, Stockholm, Sweden,

without whose permission it may not be copied, shown or handed to a third party or otherwise used, and it is to

be returned promptly upon request to Aktiebolaget Electrolux.

TITLE

BRAND

BY

DATE

SCALE

Electrolux

Weerasak J.

-

100%

Gray Scale1

G0014305ARTWORK NO.:

NOTE: THIS PAGE IS A GUIDELINE NOT AN ARTWORK

DO NOT PRINT

ARTWORK is 100% and is correct size when this line measures 80 mm

COLOUR

R EV I S ION: DATE: D ETAI L : R EQU E STE D BY: R E MA R K :

001 25 Jan 2017

Draft 01 - -

1 Feb 2017 Draft 02 - -

Table of Contents

Questions and Answers

J
Jill MorenoAug 16, 2025
Why my Zanussi Washer does not start?
- M
  Michael AtkinsAug 16, 2025
  If your Zanussi Washer doesn't start, ensure the door is firmly closed, the plug is properly inserted into the power socket, and the Start/Pause button has been pressed. Also, check if the “Delay Start” function is activated and cancel it if you want to wash immediately. Finally, check your domestic electrical installation to ensure there is power at the socket. If code “ ” appears on the display, wait until the main supply is stable as the appliance will start automatically.
R
Robert RichardAug 19, 2025
How to open Zanussi ZWH71246 door?
- L
  Lisa WallaceAug 19, 2025
  If your Zanussi Washer door won't open, wait until the end of the cycle. If there is water in the drum, you must drain the water to open the door. In case of appliance failure, contact Service.
D
Dawn WilliamsAug 21, 2025
What to do if Zanussi ZWH71246 does not fill the water?
- S
  Stephanie HarperAug 21, 2025
  If your Zanussi Washer is not filling with water, the water tap might be closed. Open the water tap and check the inlet hose connection. Also, the filter in the inlet hose could be blocked, so clean the water inlet hose filter. Finally, ensure that the door is properly closed.
J
Jason BennettAug 25, 2025
Why Zanussi ZWH71246 Washer spinning starts late?
- R
  Raymond JohnsonAug 26, 2025
  If the spinning cycle starts late or your Zanussi Washer doesn't spin, the electronic unbalance detection device may have been activated because the laundry isn't evenly distributed in the drum. Pause the machine and redistribute laundry manually.
M
Mrs. Amanda HendricksAug 27, 2025
What to do if there is water on the floor near Zanussi ZWH71246 Washer?
- L
  Lisa KnoxAug 28, 2025
  If there is water on the floor, it could be due to several reasons. You might be using too much detergent or an unsuitable type that creates excessive foam. Reduce the detergent quantity and use the correct type. Also, check the water inlet hose connection for any leaks. If the drain hose is damaged or water leaks inside the machine, call service or disconnect the main plug from the main socket, turn off the water tap and contact your local Service Centre.
Y
Yvette MartinezAug 31, 2025
How to reduce vibration of Zanussi ZWH71246 Washer?
- A
  Amber WolfeAug 31, 2025
  If your Zanussi Washer vibrates or is noisy, it could be due to a few reasons. First, make sure that the transit bolts and packing have been removed and that the support feet have been adjusted correctly to level the appliance. Also, check if the laundry is evenly distributed in the drum; if not, pause the machine and redistribute it manually. If there is very little laundry in the drum, load more laundry.
V
Valerie LeSep 3, 2025
Why Zanussi Washer fills then empties immediately?
- A
  Alexandria MooreSep 3, 2025
  If your Zanussi Washer is filling and then immediately emptying, it could be because the end of the drain hose is too low. Check the drain hose connection. Also, the drain hose might be squashed or kinked, so inspect it for any obstructions. The drain pump could also be clogged, so clean the drain filter.
G
George LoweSep 5, 2025
How to improve washing results with Zanussi Washer?
- D
  Diane BakerSep 5, 2025
  If you're experiencing unsatisfactory washing results with your Zanussi Washer, you might be using too little or unsuitable detergent. Increase the detergent quantity or use a different detergent. Also, if you have stubborn stains, treat them prior to washing with commercial products. Check if you have selected the correct temperature and reduce the laundry load if it's excessive.
M
Madison HolmesSep 9, 2025
Why Zanussi ZWH71246 cycle time longer than displayed?
- J
  jonestamaraSep 9, 2025
  If the cycle time is longer than displayed on your Zanussi Washer, you may have used too much detergent. Reduce the detergent quantity or use another one. The machine might also be unbalanced; redistribute laundry manually in the drum and start the spin phase again.
A
Amber MillerSep 12, 2025
Why Zanussi ZWH71246 makes an unusual noise?
- B
  beckterrySep 12, 2025
  If your Zanussi Washer makes an unusual noise, ensure the levelling of the appliance is correct. Also, make sure that the packaging and/or the transit bolts are removed. If the load is too small, add more laundry in the drum.

Summary

1. Safety Information

1.2 Child Safety

Safety precautions related to children's interaction with the appliance.

1.3 Child Safety Device

Details on the child safety lock feature to prevent door closure.

1.4 General Safety Guidelines

General safety guidelines and warnings for using the appliance.

1.5 Installation Precautions

Instructions and precautions for installing the washing machine.

1.6 Usage Guidelines

Guidelines for the proper and intended use of the appliance.

5. Daily Use Operations

Loading and Detergent Use

Guidance on loading laundry and using detergents/additives.

Program Selection and Start

6. Washing Hints

6.3 Pre-Wash Loading Checks

6.5 Stain Removal Techniques

Techniques for pre-treating and removing common stains.

6.6 Detergent Type and Quantity

Advice on selecting and using the correct detergent.

8. Care and Cleaning

9. Troubleshooting

9.1 Possible Failures

Common malfunctions and their possible causes and solutions.

9.2 Emergency Door Opening

Procedure for opening the door in emergencies.

10. Technical Data

11. Installation

11.1 Unpacking Guide

Instructions on how to unpack the appliance.

11.2 Machine Positioning

Guidance on placing and levelling the washing machine.

11.3 Water Inlet Connection

11.4 Water Drainage Options

11.5 Electrical Connection

2. Product Description

2.1 Component Parts

3. Control Panel

3.1 Panel Description

3.2 Display Indicators

3.3 Program Chart

3.5 Detailed Options

3.7 Start;Pause and Add Clothes Controls

4. Before First Use

Zanussi ZWH71246 Specifications

General

Washing Capacity	7 kg
Spin Speed	1200 rpm
Energy Efficiency Class	A+++
Dimensions (H x W x D)	85 x 60 x 55 cm
Noise Level (Spinning)	76 dB
Programs	15
Type	Freestanding
Loading type	Front Load
Delay start	Yes
Child lock	Yes

Related product manuals

Preview: Zanussi ZWH7120

Zanussi ZWH7120

Zanussi ZWH7122J

Preview: Zanussi ZWH71046

Zanussi ZWH71046

Preview: Zanussi ZWH 6125

Zanussi ZWH 6125

Preview: Zanussi ZWH 7100 P

Zanussi ZWH 7100 P

Preview: Zanussi ZWH 7160 P

Zanussi ZWH 7160 P

Zanussi ZWH 7122 J

Preview: Zanussi ZWH 6160 P

Zanussi ZWH 6160 P

Zanussi ZWH 7148 P

Zanussi ZWH 7162 J

Zanussi ZWH 7140 P

Zanussi ZWH 6140 P