USING GAME WAVE PLAYER
1. Make sure that all connections to
the TV, VCR, or other A/V devices are
complete.
2. Turn on the Game Wave by press-
ing the power button.
3. When finished, turn off the Game
Wave by pressing the power button.
To eliminate all voltage inside the unit,
turn off the Game Wave and then
unplug the power cord from the
power outlet.
1. Remove battery cover on back of remote.
2. Insert two AAA batteries, making sure the
polarity (+/-) matches the marks inside the remote.
3. Replace the cover. Do not attempt to recharge,
short circuit, disassemble, heat or throw the
batteries in a fire. Do not mix old and new
batteries. Dispose of batteries properly in
accordance with local law.
Note: Old or weak batteries can leak and severely
damage the remote control units.
PLAYING GAME WAVE GAMES
LOADING BATTERIES IN
REMOTE CONTROLS
The Game Wave can only play games with the Game Wave logo on them.
To start a game
1. Press the OPEN/CLOSE button to
open the disc tray.
2. Place the game disc seated level in
the disc tray with the label facing up.
3. Press the OPEN/CLOSE button to
close the disc tray. After a brief pause
the game will start.
To end a game
1. Press the OPEN/CLOSE button to
open the disc tray.
2. Remove the game disc.
3. Press the OPEN/CLOSE button to
close the disc tray.
* Turn off Game Wave when not in use.
Back of Remote
Front of Game Wave Unit
POWER
OPEN/CLOSE
TROUBLESHOOTING
The power is on,
but Game Wave
does not work
No picture
No sound
The picture is poor
or flickers
The Game Wave
will not play
movies or games
The remote
control does not
work properly
No disc is inserted
The TV is not set to receive the
signal output from the Game
Wave
The video cable is not
connected properly to the TV
or Game Wave
The equipment connected with
the audio cable is not set to
receive the signal output
Volume is low or muted
The audio cable is not
connected properly
The disc is dirty
The video cable is not
connected securely to the TV
or Game Wave
No disc is inserted
An unplayable disc is inserted
The disc is inserted upside
down
The disc is dirty or scratched
The setup or on-screen menu
is shown on the TV screen
The remote control is too far
from the Game Wave player
There is an obstacle in the
path of the remote and the
Game Wave player
The batteries in the remote
control are exhausted
Insert a disc
Select the appropriate video
input mode on the TV so the
picture appears on the screen
Make sure the yellow AV cable or
S-Video cable is connected
securely to the correct jack on
the TV or Game Wave
Set your audio receiver to the
correct input mode so that sound
can be heard
Turn volume up
Make sure the red and white
audio cables are connected to
the red and white jacks securely
Clean the disc
Make sure the yellow AV cable or
S-Video cable is connected sec-
urely to the TV or Game Wave
Insert a disc
Insert a playable disc (Check the
disc type, color system, and
Regional Code)
Make sure the disc is inserted
with the label facing up
Make sure the disc is clean and
not scratched
Press the SETUP or MENU
button on your remote to close
the menu
Use the remote within approx.
12 feet of the Game Wave
Make sure there is a clear path
between the remote and the front
of the Game Wave Player
Replace the batteries
SYMPTOM CAUSE CORRECTION
8
5
GameWaveManual_PrinterSpreads.qxp 6/14/2006 2:50 PM Page 9
To Next Page
Loading...
Need help?
General