Important
Tip Start assembly from bottom to top.
DO NOT place unit on its side or back as
it will compromise its structural integrity.
THIS SIDE UP
WARNING: CHOCKING HAZARD
Small parts NOT for children under 3 years
1
2
3
4
5
6
Carefully remove the 3M
protective layer from adhesive.
Place alignment pins
in vertical zBoards.
Align horizontal zBoard and press firmly
to secure unit together. Visit links below
for more details.
Enjoy building possibilities!
Fit backboard into horizontal zBoard
groove.
Arrange vertical zBoard with grooves
facing backboard as shown.
Align vertical zBoards to backboard.
1 Backer Board
thin and has no adhesive
2 Horizontal zBoards
with grooves
2 Vertical zBoards
adhesive strips on 2 edges
12 Pins
Included
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
• When moving your furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry
CUBE
To Next Page
Need help?
General