17
COLD WATER USE
WARNING
1. The high-pressure outlets (HP Ports) are distinctly larger than the
low-pressure outlets. Only devices with fittings, hoses and components
designed for the full tank pressure that the regulator will be mounted on,
such as Submersible Pressure Gauges, are to be installed in these ports.
2. During installation, the O-ring hose fittings will seal with hand- tight
pressure, but may come loose during use if not tightened carefully with
a small wrench. Proper torque for the hose fittings is 40-45 in lbs. (4.5-5
N-m) Excessive tightening won't help the seal and may damage the parts.
WARNING
Extreme cold water diving such as diving under ice requires specialized
training, certification and procedures. Do not attempt these activities
unless you are fully qualified and properly equipped to do so safely.
To Next Page
Loading...
Need help?
General
