EC50 Enterprise Computer Quick Start Guide
13
3.
Insert the microSD/SIM card access drawer into the device.
Device Charging
Before using the device for the first time, charge the device until the green Charging/Notification light
emitting diode (LED) remains lit. To charge the device use a cable or a cradle with the appropriate power
supply.
The device’s Charging/Notification LED indicates the status of the device charging. See Table 1 on
page 14 for device charging status. The device charges from fully depleted to 90% in approximately three
hours.
NOTE: In many cases the 90% charge provides plenty of charge for daily use.
To achieve the best fast charging results use only Zebra charging accessories. Charge the device at room
temperature.
Charging Indicators
Table 1 Charging/Notification LED Charging Indicators
State Indication
Off Device is not charging. Device is not inserted correctly in the
cradle or connected to a power source. Charger/cradle is not
powered.
Slow Blinking Amber (1 blink every
4 seconds)
Device is charging.
Slow Blinking Red (1 blink every
4 seconds)
Device is charging but the battery is at end of useful life.
Solid Green Charging complete.
To Next Page
Loading...
Need help?
General
