Zebra ET50 User Manual (English)

To Next Page

ET5X

Expansion Back

Installation Guide

Installation

Regulatory

This guide applies to the following Model Numbers: ZBK-ET5X-10RH1, ZBK-

ET5X-10SCN, ZBK-ET5X-8RH1 and ZBK-ET5X-8SCN.

All Zebra devices are designed to be compliant with rules and regulations in

locations they are sold and will be labeled as required.

Local language translations are available at the following website: http://

www.zebra.com/support.

Any changes or modifications to Zebra equipment, not expressly approved by

Zebra, could void the user's authority to operate the equipment.

For use only with Zebra approved and UL Listed mobile computers, Zebra

approved, and UL Listed/Recognized battery packs.

Health and Safety Recommendations

Ergonomic Recommendations

• Reduce or eliminate repetitive motion

• Maintain a neutral postures

• Reduce or eliminate excessive force

• Keep objects that are used frequently within easy reach

• Perform tasks at correct heights

• Reduce or eliminate vibration

• Reduce or eliminate direct pressure

• Provide adjustable workstations

• Provide adequate clearance

• Provide a suitable working environment

• Improve work procedures

Laser Devices

Class 2 laser scanners use a low power, visible light diode. As with any very

bright light source such as the sun, the user should avoid staring directly into

the light beam. Momentary exposure to a Class 2 laser is not known to be

harmful.

The following statement is required to comply with US and international

regulations.

CAUTION: Power off the ET5X before installing or

removing Expansion Back.

Remove battery cover and store in safe place.

Rubber Gasket

On 8” version only, remove rubber gasket.

8” Configuration

Align expansion back with device. Ensure that the power

pack slot cover is aligned with the bottom of the device and

the interface connector on expansion back aligns with

interface connector on device.

Interface

Connector

Power Pack Slot

Cover

10”

Configuration

Interface

Connector

Power Pack Slot

Cover

Screws (4)

Using a T6 Torx screwdriver, secure expansion back to

device using four screws. Torque to 14 n-cm.

CAUTION In order to avoid or minimize the potential risk of

ergonomic injury follow the recommendations below.

Consult with your local Health & Safety Manager to

ensure that you are adhering to your company’s safety

programs to prevent employee injury.

CAUTION Use of controls, adjustments, or the performance of

procedures other than those specified herein may result

in hazardous laser light exposure.

Need help?

Do you have a question about the Zebra ET50 and is the answer not in the manual?

Zebra ET50 Specifications

General

Stepping	C0
Processor code	SR1SK
Processor cache	2 MB
Processor cores	4
Processor model	Z3795
System bus rate	- GT/s
Processor family	Intel Atom®
Processor series	Intel Atom Z3700 Series
Processor codename	Bay Trail
Processor frequency	1.59 GHz
Processor cache type	L2
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	17 x 17 mm
Conflict-Free processor	Yes
Processor front side bus	- MHz
Processor boost frequency	2.39 GHz
Processor operating modes	32-bit, 64-bit
Thermal Design Power (TDP)	2 W
LED backlight	-
Display diagonal	10.1 \
Touch technology	Multi-touch
Touchscreen type	Capacitive
Display resolution	1920 x 1200 pixels
Internal memory	2 GB
Memory clock speed	1066 MHz
Internal memory type	LPDDR3-SDRAM
Maximum internal memory	4 GB
Storage media	eMMC
Compatible memory cards	SDXC
Maximum memory card size	2000 GB
Internal storage capacity	32 GB
Number of built-in speakers	2
Flash type	LED
Rear camera type	Single camera
Video recording modes	1080p
Rear camera resolution (numeric)	8 MP
Front camera resolution (numeric)	2 MP
Battery capacity	8700 mAh
Battery life (max)	- h
Microphone in	No
HDMI ports quantity	0
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Micro-USB 2.0 ports quantity	1
Operating vibration	1.9 G
Non-operating vibration	4.1 G
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Platform	Android
Operating system installed	Android 6.0
Graphics card	HD Graphics
Wi-Fi standards	802.11a, Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth version	4.0
Top Wi-Fi standard	Wi-Fi 5 (802.11ac)
Device type	Mobile tablet
Form factor	Slate
Product color	Black
International Protection (IP) code	IP65
Processor ARK ID	80267
Processor socket	BGA 1380