8 ET5X Enterprise Tablet
Install a micro SD Card
To install a microSD card:
1. Open access door.
2. Insert microSD card into slot with contacts facing down.
3. Press the card in to ensure that it is seated properly.
4. Close access door.
Charging the ET5X
Use the Communication and Charging Cradle, Rugged Communication and Charging Cradle or
Charge Only Cradle to charge the ET5X.
NOTE The Charge Only Cradle (CRD-ET5X-1SCG1-01) and the Communication and
Charge Cradle (CRD-ET5X-1SCOM1-01) come with two inserts; tall insert and short
insert. Install the tall insert when using an ET5X without a Rugged Frame or
Expansion Pack. Install the small insert when using an ET5X with an Expansion
Pack and without a Rugged Frame. Do not install either insert when using the ET5X
with the Rugged Frame.
The Rugged Communication and Charge Cradle (CRD-ET5X-1SCOM1R-01) does
not come with inserts. Use with ET5X and Rugged Frame with IO Adapter.
Communication CradleCharge Only Cradle
Short Insert
Rugged Communication Cradle
Tall Insert
To Next Page
Loading...
