Zebra Z4M - Page 102

94 Zebra Z4M/Z6M Printers User’s Guide
L
LCD Error Conditions and Warnings, 69
Liner Removal, 27, 29
Liner Take-up Mode, 26
Lubrication, 65
M
Media Loading
Cutter Mode, 23
Fanfold, 32
Liner Take-up Mode, 26
Power Peel/Rewind (Peel Mode), 28
Power Peel/Rewind (Rewind Mode), 30
Tear-off Mode, 22
Value Peel-off Mode, 24
Media Removal, 31
Media Requirements, 2
Media Sensor Positioning, 9
Media Specifications, 83
Media Types
Continuous Media, 7
Non-Continuous Black Mark Media, 7
Non-Continuous Web Media, 6
N
Non-Continuous Black Mark Media, 7
Non-Continuous Web Media, 6
O
Operator Controls
Front Panel, 13
POWER Switch, 13
P
Parallel Cabling Requirements, 91
Parallel Data Communications, 91
Parallel Interface, 91
Password-Protected Parameters, 38
PAUSE Key Self Test, 77
Positioning the Media Sensor
Reflective Sensor, 9
Transmissive Sensor, 10
Power Cord Specifications, 85
Power Peel/Rewind (Peel Mode), 28
Power Peel/Rewind (Rewind Mode), 30
POWER Switch, 13
Print Mode, 8
Print Quality Problems, 71
Printer Calibration, 5
Printer Diagnostics, 75
Printer Interface Technical Information
Hardware Control Signal Descriptions, 89
Parallel Data Communications, 91
Parallel Interface, 91
RS-232 Interface, 88
RS-485 Interface, 90
Serial Data Communications, 87
Printer Overview, 4
Printer Power, 3
Printhead Pressure Adjustment, 65
Printing a Test Label, 15
Printing Specifications, 82
R
Reflective Sensor Adjustment, 10
Reflective Sensor Positioning, 9
Reporting Damage, 2
Rewind Media Alignment, 67
Ribbon Loading, 11, 34
Ribbon Removal, 36
Ribbon Requirements, 2
Ribbon Specifications, 82
Roll Media Loading, 22–33
RS-232 Interface, 88
RS-485 Interface, 90
S
Self Tests
CANCEL Key, 76
Communications Diagnostics, 79
FEED Key, 78
PAUSE Key, 77
Serial Data Communications, 87