Zebra Z4M - Page 47

Zebra Z4M/Z6M Printers User’s Guide 39
/HDYLQJWKH6HWXS0RGH
You can leave the program mode at any time by pressing the SETUP/EXIT key. The
“SAVE CHANGES” display appears. There are five choices, which are described
below. Pressing the INCREMENT (+) or DECREMENT (–) key displays other
choices and pressing the SELECT key selects the displayed choice.
• PERMANENT — Permanently saves the changes. Values are stored in the printer
even when power is turned off.
• TEMPORARY — Saves the changes until you change them again or until power is
turned off.
• CANCEL — Cancels all changes from the time you pressed the SETUP/EXIT key
except for darkness and tear-off settings (if they were changed).
• LOAD DEFAULTS — Loads factory defaults.
• LOAD LAST SAVE — Loads values from the last permanent save.