Zebra Z4M - Page 52

44 Zebra Z4M/Z6M Printers User’s Guide
Display Shows Action/Explanation
INITIALIZE CARD
Initialize Memory Card
CAUTION: Perform this operation only when it is necessary to erase all previously
stored information from the optional memory card. Press the SETUP/EXIT key to
bypass this function.
1. Press the INCREMENT (+) key to select “YES.”
,I\RXUSULQWHULVVHWWRUHTXLUHDSDVVZRUG\RXDUHSURPSWHGWRHQWHU
WKHSDVVZRUG(QWHUWKHSDVVZRUGDQGWKHQSUHVVWKH6(/(&7NH\
2. The display asks “INITIALIZE CARD?”. Press the INCREMENT (+)
key to select “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the INCREMENT (+) key “YES” to begin initialization.
RU
Press the DECREMENT (–) key “NO” to cancel the request and return to the
“INITIALIZE CARD” prompt.
5. Press the SETUP/EXIT key followed by the SELECT key. If initialization
is still in process, the front panel display flashes back and forth between
the two phrases “CHECKING B: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer automatically exits the
configuration mode and the front panel displays “PRINTER READY.”
NOTE: Depending on the amount of memory in the memory card,
initialization may take up to five minutes to complete.
INIT FLASH MEM
Initialize Flash Memory
CAUTION: Perform this operation only when it is necessary to erase all previously
stored information from the FLASH memory. Press the SETUP/EXIT key to bypass
this function.
1. Press the INCREMENT (+) key to select “YES.”
,I\RXUSULQWHULVVHWWRUHTXLUHDSDVVZRUG\RXDUHSURPSWHG
WRHQWHUWKHSDVVZRUG(QWHUWKHSDVVZRUGDQGWKHQSUHVVWKH
6(/(&7NH\
2. The display asks “INITIALIZE FLASH?”. Press the INCREMENT (+)
key to select “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the INCREMENT (+) key “YES” to begin initialization.
RU
Press the DECREMENT (–) key “NO” to cancel the request and return to
the “INITIALIZE FLASH” prompt.
5. Press the SETUP/EXIT key followed by the SELECT key. If initialization
is still in process, the front panel display flashes back and forth between
the two phrases “CHECKING E: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer automatically exits the
configuration mode and the front panel displays “PRINTER READY.”
NOTE: Depending on the amount of free FLASH memory, initialization may
take up to one minute to complete.