ZEHUS BIKE+ - Getting Started and Bike Operation; 1. Getting Started

5
1. Getting started with BIKE+ all in one
1.1 Intended use
BIKE+ all in one is intended to be used exclusively with the bike which was sold with. Any
attempt to mount BIKE+ all in one on another bike will void warranty claims.
BIKE+ all in one is not permitted for competition and race use.
1.2 Initial operation
BIKE+ all in one can only be activated when the battery state of charge is sufcient. In
order to check the battery state of charge of your BIKE+ all in one please refer to 5.
1.3 Turning on the system
BIKE+ all in one turns on automatically when the rear wheel reaches a speed higher
than 5 km/h. Thus, to turn on BIKE+ all in one just start pedaling your bike as usual or spin
the wheel while you lift the bike, as explained in Figure 2 .
I
2
3
Figure 2: in order to turn on BIKE+ all in one, lift the bike (1), push the
pedal (2) such that the rear wheel reaches at least 5 km/h (3).