Need help?Do you have a question about the ZEISS IKON MOVISCOP and is the answer not in the manual?
General| Category | Recording Equipment |
|---|---|
| Manufacturer | Zeiss Ikon |
| Model | Moviscop |
| Regular 8 | Yes |
| Film width | 8mm |
| Film Format | 8mm |
Describes the optical balance system that scans film frames with a rotating glass-prism in a drum shutter.
Explains focusing via a screw below the cutter and marking the film with a minute incision.
Details connecting to AC mains and adjusting voltage controls for 110-240 volts.
Covers switching on the projector lamp and fitting rewinders to the base board.
Identifies fast and slow winders, focusing knob, and film marking knob.
Details film guide rollers, light hood, fillister heads, image field lens, and casing.
Locates tumbler switch, lamp socket, voltage control, and fuse cap.
Guides on adjusting the Moviscop for different mains voltages using the voltage control.
Explains the miniature cine lamp, its position, and the heat-filtering condenser.
Details the simple process for exchanging the projector bulb by removing the light house.
Describes how to use the knob to create a 1 mm incision for marking the film.
Instructs on threading film onto the spool and adjusting winder friction for projection.
Outlines two methods for rewinding film: through the apparatus or separately.
Emphasizes keeping the film track and optical prism clean to prevent scratches and ensure image clarity.
Recommends regular lubrication of the rewinders through designated oil holes.
Describes the film pressure pad feature for preventing focus drift on the curved film track.
To Next Page