Need help?Do you have a question about the Zeiss 432610-9060-000 and is the answer not in the manual?
General| Input Voltage | 100-240 V AC |
|---|---|
| Input Frequency | 50-60 Hz |
| Output Voltage | 24 V DC |
| Output Current | 2.5 A |
| Power | 60 W |
| Efficiency | >85% |
| Protection | Overvoltage, Short Circuit |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to +70°C |
Ensures proper socket use with earth conductor. Avoid extension cables without grounding to prevent contact with mains voltage.
Keep devices and accessories away from moisture. Damaged housings must be decommissioned to avoid electric shock.
Always switch off and unplug before cleaning or opening. Disconnect before changing fuses to prevent electric shock.
Use only specified power cables. Do not replace with non-compliant cables to prevent overheating and fire.
If safety measures fail, take the device out of service. Contact ZEISS Service for repairs to avoid injury.
Do not cover ventilation slats or the device when off. Failure to comply may cause heat buildup, damage, or fire.
Use only specified fuses. Do not use other fuses or short-circuit the fuse box to prevent overheating or fire.
Dispose of defective equipment according to national laws. Do not use domestic waste. Manufacturer accepts returns.
Provides physical dimensions of the Power Supply unit.
Specifies the weight of the Power Supply unit.
Details admissible temperature, humidity, altitude, and pressure for transportation, storage, and operation.
Covers environment for use, protection class, electrical safety, EMC, noise immunity, line voltage, frequency, and power consumption.
Specifies the type and rating of fuses required for the Power Supply unit.
Identifies sockets for RL illuminator, TL illuminator, remote control cable, and mains connection on the rear of the unit.
Instructions for connecting HAL 100 lamps to microscope mounts and the Power Supply unit.
How to connect the microscope stand via control cable for brightness regulation using remote control.
Identifies the front panel controls: ON/OFF switch, dimmer, pilot lamp, and selector switch.
Steps to turn on the Power Supply unit and the microscope.
To Next Page