Opening and cleaning the air lter
1. Grab the hook on the bottom of the air inlet grill with the lter, pull it out and remove the air lter from
the lter cover.
2. Wash the air lter by immersing it gently in warm water (about 40°C) with a neutral detergent.
3. Rinse the lter and dry in a shady place.
4. Attach the lter back to the appliance.
BEFORE THE START OF THE SEASON
1. Check if the air inlets and outlets are not blocked.
2. Make sure the air lter is properly installed before operating the air conditioner. If the air conditioner
is operated with the air lter removed, dust and foreign objects may result in faulty performance of the appliance.
BEFORE THE END OF THE SEASON
1. Switch off and unplug the air conditioner.
2. Clean the air lter and other parts.
3. Twist off the release stopper and remove the water. Run the air conditioner in the ventilation mode for about half a day for the unit to dry
thoroughly.
4. Cover the appliance to protect it from dust and dirt.
TROUBLESHOOTING
Please check the table below before contacting the service center.
Problem Check Solution
The air conditioner does not
operate.
Is the power on?
Is the appliance unplugged?
Has the fuse blown?
Is the water container indicator illuminated?
Is the water container properly installed?
Is the operating time properly set?
Plug in the appliance.
Change the fuse.
Empty the water container.
Correctly install the water container.
Change the time settings.
Weak cooling effect
Is the air inlet or outlet clogged?
Is there another heat source in the room?
Are the air lters dirty?
Is the temperature correctly set?
Is the fan speed appropriate?
Unblock the airow.
Remove the heat source from the room.
Clean the lter.
Change the set temperature.
Change the fan speed to high.
Noise and vibration Is the air conditioner standing on a at, even surface? Place the air conditioner on a at, even surface.
The air conditioner automatically
switches on and off.
Is the voltage in the power source appropriate?
Is the exhaust duct bent or clogged?
Is there an additional air outlet independently installed?
Check the power source.
Make sure the exhaust duct is in a horizontal position.
Check if hot air is correctly channeled.
ATTENTION: If the air conditioner still does not work, immediately unplug the appliance and contact an authorized service center.
SELF-DIAGNOSIS FUNCTION
The air conditioner has a built-in diagnosis system which informs the user about the improper functioning of the appliance.
Failure code Failure diagnosis
E2 Sucked air temperature measurement failure.
E3 Appliance operating at a too high temperature.
E4 Appliance protection against irregularities.
E5 The water level is too high.
PERIODIC INSPECTION OF THE APPLIANCE
1. Systematically perform obligatory inspections of the appliance every 10–14 months.
2. Report the appliance for inspection to the authorized service center.
3. The cost of the inspection is covered by the owner of the appliance.
ECOLOGY – ENVIRONMENTAL PROTECTION
Each user can protect the natural environment. It is neither difcult nor expensive.
In order to do it: put the cardboard packing into recycling paper container; put the polyethylene (PE) bags into container for
plastic.
When worn out, dispose the appliance to particular disposal centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
The terms and conditions of the warranty are pursuant to the regulations in force in the country the product is sold.
The manufacturer does not accept any liability for any damages resulting from unintended use or inappropriate handling. The manufacturer reserves his rights for modifying
the product any time in order to adjust it to law regulations, norms, directives, or due to construction, trade aesthetic or other reasons, without notifying it in advance.
Air inlet grill
with lter
Handle
GW 23-008
To Previous Page
Loading...