Selecting the fry function or the steam
function (Fig. E)
1
After selecting the Meat, Fish or Vegetables function,
the icon „steam” will begin to ash on the display The “Meat”
function has been selected as an example.
2
In order to change the “Steam” function into the „Fry”
function, press the “Steam/Fry” button (24).
3
The appliance will display the minimum cooking time for
the selected function (see the table (Fig. J)).
Then, proceed according to the user manual.
Changing the cooking time (Fig. F)
1
After selecting the desired function, in order to change
the cooking time it is necessary to press the “Timer” button
(25). The cooking time setting will begin to ash on the
display.
2
Use the button in order to set the desired cooking
time.
When the maximum cooking time for the
selected function exceeds 60 minutes, you can
use the button to change the hour setting.
The appliance is also provided with the “Preset”
function. You can optionally set the end of cooking time.
3
In order to set the end of cooking time, press “Preset”
button (26). The time setting selected in the previous cooking
cycle will ash.
4
In order to change the time setting, use the button
(hour setting) and the button (minute setting).
5
After setting the function and the cooking time or
optionally applying the “Preset” function, press the “Start”
button (28). The appliance will start the cooking process
unless the “Preset” function has been selected.
6
After nishing the cooking cycle the appliance will go into
the keep warm mode and the message “End” will appear on
the display.
In order to achieve good cooking results, it is
necessary to use the proper functions with the
time settings properly selected for cooking or
frying a particular dish. Extend the cooking
time when necessary.
Additional Reheat and Boil functions (Fig. G)
The “Preset” option is not available for the
Reheat and Boil functions.
1
Press the “Menu/ON” button (23) and select the
„Reheat” function or the „Boil” function by means of the or
button.
The appliance will display the minimum cooking time for
●
the selected function (see the table (Fig. J)).
2
In order to change the time setting, press the “Timer”
button (25) (the time setting will begin to ash on the display).
Then, set the time by means of the button.
Then, after setting the desired function, press the
●
“Start”
button (28).
In order to speed up the cooking of certain
products or dishes, before starting the desired
function you can boil the water using the Boil
function and then set the desired function in
order to continue cooking.
The temporary store function: If during the
cooking process the appliance has been
disconnected from the electricity supply for not
longer than 30 minutes, the cooking process will
be automatically resumed after reconnecting
to the electricity supply. If the appliance has
been disconnected from the electricity supply
for more than 30 minutes, the appliance will be
automatically turned to the stand-by mode after
reconnecting to the electricity supply.
After the cooking (Fig. H)
Turn off the appliance and disconnect the power cord
●
from the mains outlet.
Before starting to dismantle the appliance,
make sure that the appliance has been
disconnected from the electricity supply and
that the appliance interior has cooled down to
the room temperature.
1
Open the lid by means of the lid release mechanism (7).
2
Remove the pot (14) and the optional steam basket
(15)).
3
Dismantle the removable inner lid (4) by pulling up the
removable inner lid release mechanism (2).
4
Dismantle the steam valve (11) by pulling it up.
5
Separate the two parts of the steam valve by turning the
lower part anti-clockwise.
6
Remove the drip tray (20).
Wash all the elements following the rules provided in the
●
Cleaning and maintenance section (Fig. I)
Once the elements have dried up, reassemble the
●
appliance in the reverse order.
If mounted improperly, the steam valve
may have negative impact on the quality of
appliance operation.
After each use of the appliance, empty the drip
tray (20) located at the rear of the appliance.
To Next Page
Loading...
