Zempire EVO TM V2 - Page 2

SIDE
FRONT
KEY TIPS
REAR
2 3
EVO TM
V2
AIR TENT
OPTIONAL ADD ONS
EVO TMTS
V2
AEROBASE LINK
Connects your Aerobase 3 or 3 Pro shelter to
your Evo TM
V2
tent to extend your outdoor
living space. Ideal as a kitchen, lounging or
dining space.
EVO TM
V2
ROOF COVER
Helps reduce internal temperature and keeps
the inside of your tent darker. Also protects your
roof from pollen, tree sap and other debris.
EVO TM
V2
SOLID GROUND SHEET
Designed to protect the tent floor and simplify
clean-up. Made from PE, it fits perfectly under
your tent with corner peg points.
Internal window panels can be
half opened to control airflow and
privacy. Fold window panels so
they sit between the lower cover
and mesh panel.
When rolling up door panels, fold
the outer corners into the centre
and roll inwards. This prevents the
edges hanging loose and prevents
water from pooling in the roll.
On warm or humid nights, zip
down the top of the 360° door
cover. This provides maximum
ventilation while maintaining your
privacy.
Before inflating your tent, start by
pegging the corners and ensure
the tent is fully pegged with the
floor sitting flat. The floor seam
should have tension between each
peg loop.
PSI
Ensure all doors are zipped closed
before inflating and deflating. This
helps the tent keep its shape and
prevents undue stress on panels
and zips.
Ensure your air tubes are inflated
to the correct pressure by using the
pressure release valve and gauge
on the pump.
Twist anchor webbing straps into
a spiral before pegging to prevent
them flapping in the wind.
Do not over tension guy ropes,
the guy ropes should be taught
but shouldn’t pull your tent out
of shape.
EVO TMTS
V2
AWNING WALL SET
Enjoy two different options to enclose the
awning space of your EvoTM
V2
or EvoTS
V2
tent.
Both a fully waterproof poly wall and bug-proof
mesh wall are included.