Zenit 12 - Page 26

Troubleshooting
If this happens ...
Here is why...
And how to correct it. . .
After loading, Frame
Counter
[4]
skips
two
or
more numbers after being
set to '0' position.
Film transport Lever [2] not
fully wound before counter
is set to '0' position.
Advance Transport Lever
fully before setting counter
to '0'.
Frame Counter [4] ‘skips’,
counting incorrectly.
See above — or Counter set
before Transport Lever was
wound.
See above — always wind
Transport Lever before
setting counter.
Self-Timer does not trip
shutter.
Self-Timer Lever [8] not
fully wound. Transport lever
[2]
not
wound.
Wind Self-Timer Lever fully
until lever points
downwards with no further
movement possible. Always
ensure Transport Lever is
fully wound before setting
Self-Timer Lever.
Film will not rewind.
Rewind release not
engaged.
Refer back to page 17.
If
anything
should
go
wrong
with
your
Zenith
and
the
preceding
chart
has
not
got
you
out
of
trouble
never
attempt
to
mend
it
yourself
—
you
could
turn
a
minor
adjustment
into
an
expensive
repair.
Remember that your Zenith and its
accessories are backed up by top-class
service facilities where factory-trained
specialists
are
available
to
put
things
right.