Zenith C27V22 Operating Guide And Warranty

Connect cable service to your Entertainment Machine
Locate the Antenna/Cable jack on the
back of the TV.
Connect the cable service wire that runs
from the wall or cable box directly to this
jack, according to one of the diagrams to
the right.
Remove the back of the remote and put in
two "AAA" batteries.
Backofii"_ Remote
\
i
iiii, iil,iii TyRica
Cable TV
Wall Jack
Coaxial Round Wire
(75ohm)
ANTENNA
CABLE
Hug in the TV. Do not plug it into an out-
let controlled by a switch. Your TV is
designed to operate on standard house-
how current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
Z 20 VA(_
60 Hz
Typical
Cable TV
Wall Jack
Typical
TV Back
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you're using a cable box, EZ Program might
onty ffind the channel your cable service is on
(usually channel 3 or 4). Don't worry, that's all
you need/
RF Coaxial Wire
(75ohm)
k
ANTENNA
CABLE
P A G E 8 2o6-34s0-o

Zenith C27V22 Specifications

General

Brand	Zenith
Model	C27V22
Category	Monitor
Language	English