Setting Instruction Chronograph Valjoux 7751
Please be sure to check the ZENO-WATCH internet Web site for the latest listing of
World Wide Service Centres at www.zeno-watch.ch
Thank you for purchasing an original ZENO Timekeeper. To ensure correct use, please read these
instructions carefully:
Indicators a=24h-display; b=day; c=month;
d=date; e=moon-phase; f=second-counter;
g=minute-counter; h=hour-counter; i=small-
second display
Specifications precision self-winding movement (automatic)
Swiss Made, 25 jewels, 28'800 pulsation per hour, Incabloc anti-
shock system, Nivaflex spring, tight tolerance of adjustment,
power reserve till 42 hours
The Chronograph is an independent timing system for brief
intervals of time.
Activate the Chronograph
Press pusher B
Stop the Chronograph
Press pusher B (can be activated again, by pusher A)
Reset to Zero
Press pusher C
(Chronograph functions are stopped and reset to zero)
Settings
Neutral Pos. 1 winding position (unscrew crown first)
Time Pos. 3 Adjust hour and minute by turning the
crown A clock- or anticlockwise
Day Depress the recessed button D
Date Pos. 2 turn A anticlockwise (quick adjustment)
Month Pos. 2 turn A anticlockwise (changing after 31)
Moon phase Pos. 2 turn A clockwise (quick adjustment)
Warning
Correction cannot be effected between 8pm and 2am. While
turning the hands please observe that date will change at
12pm (midnight)
The watch will now be set correctly and running. The automatic movement will keep the watch wound as long
as the watch is worn. Note Before using the Chronograph make sure the watch has been wound up!
Be sure to use the watch with the crow n pressed in (normal position). If your watch has a screw -
type crown, be sure to tighten the crown completely. Do not operate the crown with wet fingers or when the
watch is wet. Water may enter the watch and compromise water resistance. If moisture has entered the watch,
or it the inside to the crystal is fogged up and does not become clear within a day, or seawater enters the
watch, immediately the watch to a Zeno Service Centre for repair. Leaving the watch in such a state will allow
corrosion to form inside. Keep you watch clean. Dust and dirt tend to collect in gaps in the back of the case or
band. Accumulated dust and dirt may cause corrosion and soil your clothing. Clean the watch occasionally.
Use a soft dry cloth to wipe off dirt, perspiration and w ater from the case and crystal. Do not use the watch in
places where it is exposed to high temperature. Doing so may result in deterioration of the watch or parts. Do
not place the watch to a magnet. Timekeeping will become inaccurate. Store your watch in a dry place when
you are not using it. Further information see guarantee card!
To Next Page
Need help?
General