INSTALLATION
12
STEP 13
STEP 15
STEP 17
STEP 14
STEP 16
STEP 18
1. On Cyclone & Whirlwind models, be sure to pull
both grease tubes over its opening.
1. Turn on electrical supply or plug into receptacles.
1. Reinstall electrical box cover.
1. Next, fasten the 3 front screws and begin tightening
all screws from rear to front.
1. Connect duct to opening, inspect and tape all joints
with approved aluminum or duct tape.
1. Reinstall bottom splash shield by first fastening 3
rear screws, (do not tighten all the way).
To Next Page
Loading...
Need help?
General
