ZERA MTS Series User Manual

Changing of the Exit Filter
1/ 2
ZERA-Sources of series MTS
ZERA GmbH | Hauptstrasse 392 | 53639 Königswinter | Germany | Tel. +49 (0)2223 704-0
Fax +49 (02223) 704-70 | E-Mail: zera@zera.de | www.zera.de
MTS310 MTS320 MTS340
Important User Information
Warning Instructions
In this manual the red box with black text is used to warn the operator that ignoring the message or action can cause
hazard and/or damage to operator or property or test tools.
Red Box with text inside means that if ignored, damage to property or person can occur.
Safety Instructions
Observe local safety regulations, generally approved accident prevention regulations and generally approved engineering
regulations concerning safety.
Warning! Before you are going to start the changing procedure, switch off the complete test system at the
main switch Q1 (usually placed at the left side of the cabinet). Please wait until the fan has stopped!

ZERA MTS Series Specifications

General

Category	Test Equipment
Current Range	Up to 120 A (depending on model and configuration, higher with current transformers)
Modularity	Yes
Expandability	Yes
Interface	Ethernet, USB
Applications	Energy meter testing

Summary

Important User Information

Warning Instructions

Information on how red boxes with black text are used to warn operators.

Safety Instructions

Observe local and generally approved safety and engineering regulations.

Changing the Exit Filter

Step 1: Unlock Filter Mechanism

Unfix the locking mechanism at the filter before proceeding.

Step 2: Replace Filter Mat

Open the filter and replace the old filter mat with a new one.

Service and Support

Contact Information

Contact service department for technical questions.