Need help?Do you have a question about the Zero 88 Betapack 2 and is the answer not in the manual?
Electrical| operating voltage | 230 V |
|---|---|
| single phase current | 60 A |
| three phase star current | 20 A |
| three phase delta current | 30 A |
| earth leakage | less than 4 mA |
| max total load | 13.9 kW |
| load per channel | 0.1 A Min; 10 A Max |
| no load consumption | 10 W |
| input signals | 0 to + 10 V or 0 to -10 V |
| desk supply voltage | +/- 20 V nominal |
| desk supply current | 100 mA |
| input impedance | not less than 50 kΩ |
Physical| max operating temperature | 40 ºC |
|---|---|
| size free standing | 447 x 177 x 195 mm |
| size rack mounted | 483 x 177 x 195 mm |
| size wall mounted | 483 x 177 x 240 mm |
| net weight | 8 kg |
Details controls on the front panel of Betapack 2 and Betapack 2 Plus units.
Explains the tamperproof plate on DMX versions and how to access controls.
Describes the push-on/push-off test switches for channels on non-Plus models.
Explains the green LEDs indicating channel output levels and triac function.
Details the preheat adjustment for pairs of channels to set minimum output levels.
Describes the neon indicators that glow if a channel fuse is blown.
Explains the LED indicator for desk supply voltage polarity and its adjustment.
Provides instructions for using Betapack 2 Plus with remote control inputs.
Details the location and adjustment of DMX Start Address switches.
Explains the Fade/Hold switch and its effect on DMX signal loss behavior.
Describes the DMX OK and Error LEDs and their meanings for data reception.
Crucial safety warning about disconnecting mains before removing covers.
Step-by-step guide on how to remove the top and bottom covers of the Betapack 2.
Instructions for mains wiring, including voltage limits and single/three phase connections.
Details on using lockwashers, ring tags, and securing mains supply wires properly.
Explains the need for ventilation and fan fitting in enclosed racks.
Instructions for mounting the Betapack 2 in a 19" rack or on a wall.
How to access DMX links and configure options by removing the bottom cover.
Explains setting a linear or 'S' control law via a wire link on the DMX PCB.
Details how to enable built-in DMX termination using a link on the DMX PCB.
Connecting DMX cabling directly to the dimmer internally for permanent setups.
Details operating voltage, frequency, and wiring configurations for Betapack 2.
Specifies rack and wall mounting dimensions, and net weight.
Details the pin assignment for the 5-pin XLR DMX connector.
Details the pin assignment for the 8-pin DIN analogue control connector.
Warns about potential failure of high voltage tests due to CE compliance capacitors.
Specifies correct fuse types and ratings for channel outputs and inductive loads.
To Next Page
