Zero Appliances JSD 32-LN1 - Technical Data and Safety; For Your Safety; Burn - Back (Fire in the tube or chamber)

Technical Data
Name
8lt
12lt
16lt
20lt
Model No
JSD 16-LN1
JSD 24-LN1
JSD 32-LN1
JSD 40-LN1
Type of Gas
LPG
LPG
LPG
LPG
Consumption at MAX
1.50 kg/h
2.25 kg/h
3.0 kg/h
3.75 kg/h
Operating Pressure
2.8 kPa
2.8 kPa
2.8 kPa
2.8 kPa
Permit No
1008-26/1-RSA-12-A
1008-26/1-RSA-12-A
1008-26/1-RSA-12-A
1008-26/1-RSA-12-A
Product Type
CLASS 'B' FOR INDOOR INSTALLATION. CAN BE INSTALLED OUTDOORS BUT MUST BE FLUED
FLUE AVAILABLE FROM GEYSER INSTALLER
Gas Consumption as per Technical data sheet above
The unit is to be installed by a certified LPGSASA gas practitioner
If the unit is installed outside the gas water heater MUST be flued
This gas water heater will switch off within 4 minutes if no flue is fitted
NB - Only a SANS 1237 Approved 2.8kPa regulator must be fitted
NB - This appliance must be installed in accordance with SANS 10087 part 1
NB - This appliance must ONLY be installed by a LPGSASA installer
For Your Safety
This appliance is set to operate on LPG only
If you smell gas;
• Turn off the gas supply at the cylinder / bottle
• Extinguish ALL naked flames
• Do NOT operate any electrical appliances
• Ventilate the area
NB - Should the odour persist, contact your local dealer or gas suppliers immediately
Burn - Back (Fire in the tube or chamber)
In the event of a burn-back, immediately turn off the gas supply at the cylinder valve. After
ensuring that the naked flame is extinguished, re-open and re-light the appliance in the normal
manner. Should the appliance burn-back again, close the control valve and phone a service
technician.
Do NOT use the appliance again until the service technician has declared that it is safe to do so.