GAS STOVES INSTRUCTIONS
Introduction:
Congratulations, you have acquired a good quality gas association approved product. Please read this
manual carefully and fully before attempting installation and operation.
1. Where to install
This unit can be used as a freestanding appliance or if installed to be done so by a registered gas
installer. This appliance should only be used with a 9kg gas bottle. The gas bottle should be
freestanding and should not to be placed in an enclosed area e.g. in a cupboard.
Place your cooker away from objects that are flammable or which have low resistance to heat. Avoid
draughts. Do not place the cooker in front of windows or doors.
The side and rear should be at least 5cm from the walls and cupboards and suction fans should be at
least 85cm above the top of the cooker. Do not place the cooker in damp areas.
2. Connecting the gas supply
This stove is designed to use LPG GAS ONLY. If you need to convert to another type of gas, contact
a qualified gas technician.
Your appliance is fitted with a SABS approved gas hose and a gas association approved regulator.
This stove requires an operating pressure of 2.8 kPa. The gas bottle should be between 300mm to
500mm away from the appliance.
3. Battery: A D type battery (not included) can be used for electronic ignition. The battery holder is
located at the back of the stove.
Electric light (lamp)
The unit is not fitted with this feature.
Precautions
Ventilation is vital for the efficient and safe performance of this appliance.
When the stove is being used always keep the room well ventilated.
If a gas leak occurs close the gas shut off valve and open all doors and windows for maximum
ventilation.
In the event of a burn back, close the corresponding gas valve, and relocate the burner cap correctly.
Always ensure that the burner injectors (jets) are not blocked by food spillages.
Do not leave plastic or any flammable objects near the flame.
When the stove is not going to be used for some time: i.e. (when on holiday, etc) ensure that the gas
supply is turned off at the cylinders.
4. Specifications of burners
To Next Page
Loading...
General