Zero Z12

zero
HOME AUTOMATION
Z02 - SWING GATE
PG7
03. The boom has to be stopped at 45°
opening posion and balanced by spring.
if the spring is not seed follow the next
steps to balance the boom.
04. Chech the right chain connecon and
move the xing posion with installed
boom lenght.
1
2
3
01. Remove the clip [1] remove the washer
[2] and pull out the holder [3].
02. Chech the right chain and spring ten-
sion , has to be ghten.
CHAIN ADJUSTMANT
To adjust the springs tension change the chain posion, by deassembling the chain, follow the
next steps
It is important to respect this installaon order!
Otherwise, it is not possible to ensure correct installaon and operators may not
work properly!