Do you have a question about the Zeus T1 and is the answer not in the manual?
Connectivity | Wired |
---|---|
Driver Diameter | 50 mm |
Frequency Response | 20 Hz - 20 kHz |
Microphone | Yes |
Type | Over-ear |
Impedance | 32 Ohms |
Remove protective labels from earbud charging contacts for initial charging.
An external USB charger is required and not included in the package.
Earbuds automatically turn on and enter pairing mode by default when removed from the case.
Initiate pairing on your device, select "Zeus T1", and enter PIN 0000 if prompted.
Successful pairing is confirmed when the Bluetooth LED indicator stops blinking.
Simply remove the L channel earbud from the case to use it independently.
Manually pair the R channel earbud by holding MFB until pairing mode is confirmed.
Answer incoming calls with a single press; end calls with a single press.
Pause/resume playback with one press; skip tracks with two or three presses.
Earbuds automatically power off when inserted into the portable charging case.
Hold the MFB button until a voice prompt confirms the power-off action.
Re-connect device, ensure it's within range, and minimize obstacles for clear audio.
Lag may occur with certain streaming content due to audio synchronization.
Reset earbuds in case, enable device Bluetooth, and re-attempt pairing.
Details play time, standby time, charging time, battery, Bluetooth version, and range.
Details charging time and battery capacity, including number of recharges supported.