Need help?Do you have a question about the Zhermack FURNACE D and is the answer not in the manual?
Guide on interpreting manual sections, symbols, and warnings for safe operation.
Explanation of symbols like DANGER, WARNING, FORBIDDEN, and NOTE used in the manual.
Manufacturer's disclaimer of liability for improper use or non-compliance with manual instructions.
Details on warranty void conditions like improper use, unauthorized modifications, and non-original parts.
Defines categories of personnel permitted to operate and maintain the equipment.
Essential safety rules and precautions for operating the preheating furnace.
Overview of the D series ovens and their intended use in odontotechny.
Illustrated list identifying key parts of the furnace models D30, D40, D50.
Detailed explanation of each labeled component (A-M) shown in the equipment diagram.
Introduction to the control panel interface and its layout.
Explains the function of each button, LED, and display element on the control panel.
Instructions for inputting temperature, time, and rate settings for oven operation.
Information about the equipment's ID plate, manufacturer details, and serial number.
Details the meaning of safety labels and symbols found directly on the equipment.
Overview of Zhermack's design philosophy and the features of the D series ovens.
Table providing dimensions, weight, power, and other specifications for D30, D40, D50 models.
Lists components included with the equipment and optional accessories with order codes.
Specifies the acceptable temperature deviation limits for the preheating ovens.
General caution regarding careful handling to prevent injury or damage during transport.
Instructions for checking received goods for damage and handling packaging materials.
Procedures for safely moving and positioning the oven, including worker requirements.
Guidelines for proper disposal of packaging materials and the equipment itself.
General warnings and precautions to be followed before starting installation.
Specifies environmental conditions (temperature, humidity, altitude, lighting) for proper operation.
Guidelines for selecting an appropriate and safe location for the equipment.
Requirements for the surface on which the equipment must be placed, emphasizing stability.
Instructions for connecting the furnace to the electrical mains, including safety checks.
Step-by-step guide for connecting the optional aspiration unit to the oven.
Detailed procedure for powering on and preparing the furnace for operation.
Defines the intended application of the D series ovens in odontotechny.
Lists prohibited uses of the equipment that could void warranty or cause damage.
Reminder not to operate the equipment with disassembled parts and to follow procedures.
Explanation of the oven's automatic safety controls for door opening and temperature limits.
Table detailing the temperature ramp-up rates for different oven series and temperature ranges.
Initial steps for accessing and initiating the data programming mode.
Step-by-step guide for setting a delayed start time for the oven program.
Procedure for starting the oven immediately without a programmed delay.
How the optional aspirator operates automatically and how to program its shutdown temperature.
Instructions for modifying settings while a program is active or during the heating cycle.
Method for checking the programmed temperature and actual chamber temperature.
How the equipment behaves and resumes operation after a power failure.
Identification of inherent risks not fully eliminable, such as burns or fires.
Instructions for cleaning the exterior and interior of the furnace safely.
Procedures for regular checks of parts for wear, damage, or looseness.
Guidelines for repairs and modifications, emphasizing authorized personnel.
Steps to follow when bringing the equipment back into service after a shutdown.
Methods for contacting Zhermack for support, including phone and fax details.
General advice on troubleshooting and when to contact the Servicing Centre.
A table listing common issues, their likely causes, and recommended solutions.
Official document confirming the equipment's compliance with EU directives.
Document containing warranty terms and fields for equipment identification.
A logbook for recording maintenance and repair activities performed on the equipment.
Information on how to find authorized service centers for assistance.
Blank space intended for user notes, comments, or amendments to the manual.
General| Brand | Zhermack |
|---|---|
| Model | FURNACE D |
| Max. Temperature | 1200 °C |
| Type | Furnace |
| Power Supply | 50/60 Hz |
To Next Page