Zhiyun RIDER-M - Six-side Calibration Procedure

19 zhiyun-tech.com
Off-line Calibration
Six-side Calibration
NOTICE: Pay attention to the position and orientation of the mobile clamp when doing calibration.
① Laythe stabilizerstill ona
surface with the Tilt Axis Motor
facing down, until the Indicator
starts flashing 2 times each
second.
② Laythestabilizerstillona
surface with the Tilt Axis Motor
facing down, until the Indicator
starts flashing 3 times each
second.
③ Laythe stabilizerstill ona
surface with the Tilt Axis Motor
facing down, until the Indicator
starts flashing 4 times each
second.
④ Laythe stabilizerstill ona
surface with the Tilt Axis Motor
facing down, until the Indicator
starts flashing 5 times each
second.
⑤ Laythe stabilizerstill ona
surface with the Tilt Axis Motor
facing down, until the Indicator
starts flashing 6 times each
second.
⑥ Laythe stabilizerstill ona
surface with the Mobile Clamp
facing backward, until the
Indicator shines solid light.
Calibration complete!