To Next PageTo Next Page
Need help?Do you have a question about the ZIMO MN170 and is the answer not in the manual?
General| Brand | ZIMO |
|---|---|
| Model | MN170 |
| Category | Media Converter |
| Language | English |
Covers fundamental CV settings for basic decoder configuration, including addresses, operating modes, and braking.
Explains how to set and manage vehicle addresses in DCC mode, including short and extended addressing schemes.
Covers CV settings for adjusting acceleration and deceleration times, affecting the locomotive's driving behavior.
Describes the "asymmetrical DCC-Signal" (Lenz ABC) method for stopping trains at signals and slow driving.
Details how to control dimming for lighting effects, high/low beams, and direction-dependent lighting via CVs.
Covers advanced effects for function outputs, including lighting sequences, smoke generators, and uncouplers.
Explains the configuration of servos connected to the decoder, including protocol, positions, and function assignments.
Details the CV #300 procedure for modifying sound parameters like sample selection and volume during operation.
Covers basic sound settings applicable to all decoder types, including total volume and function sound controls.
Provides specific sound configuration settings for steam engines, including chuff frequency and volume adjustments.
Explains how sound volume adjusts based on engine load and acceleration for steam locomotives.
Details sound configurations for diesel and electric engines, covering motor sounds, turbochargers, and switchgear.
Covers functions for driving situations requiring specific engine sounds like coasting or notching, especially for diesels.
References CVs for enabling and configuring analog operation modes for DCC decoders.
Provides an overview of CVs related to motor control, including speed curves, regulation, and voltage reference settings.
