INSTALLATION and ASSEMBLY SAFETY INSTRUCTIONS
Please Note: Observing the following statements and warnings reduces the likelihood of serious or fatal injury.
Do not substitute parts! The parts provided have been safety tested to exceed the maximum
stresses expected to be encountered when using this product. If a part becomes damaged in any way
Fun@AdventureParks.com for replacement information.
1. Be sure that the supporting trees or uprights are secure and will support at least 1250 pounds. If you are using
uprights other than trees or are considering installation on other than level ground please
Fun@AdventureParks.com for important safety information.
2. Be sure that the area between the trees or uprights is level and at a distance of not less than 6 feet from any structure or
obstruction such as a fence, garage, house, tree trunk, interfering branches, laundry line or electrical wire.
3. The maximum fall height for this product is determined by measuring from the handles to the ground at the highest
point of attachment to the tree or upright. This will vary depending upon the height of the user and the distance between
the trees or uprights (see assembly instructions).
4. Do not install ZL35 Zip Line over concrete, asphalt, packed earth, grass, carpet or any other hard surface. A fall
onto a hard surface can result in a serious injury or death to the equipment user. (See enclosed CONSUMER
INFORMATION SHEET FOR PLAYGROUND SURFACING MATERIALS).
5. Cable height: For ZL35 Zip Line to operate properly and safely it is necessary to follow the mounting instructions
carefully and observe the height recommendations. Each end of the cable must be mounted at the same height, which
should not exceed six (6) feet.
Please Note: Observing the following statements and warnings reduces the likelihood of serious or fatal injury.
WARNING! Do not add additional slope to the cable. This will not improve the ride and may create a danger to
the user!
Assembly Instructions
NEVER USE EYEBOLTS OR SIMILAR HARDWARE IN CONNNECTION WITH THIS PRODUCT!
1. Set aside Assembled Trolley (E).
2. Carefully uncoil the galvanized aircraft cable (C).
Wrap one end around one of the uprights at the height chosen.
To Next Page
Loading...
Need help?
General