How to Install Zip Line without Trees
1) Determine if you will need to install post’s on one side of zip line ride or both sides (each
side will require Qty. 2: 6’ x 6’ x 12’ long posts).
2) For each side you will be using post’s instead of trees:
a. Bolt Two 6’ x 6’ x 12’ pressure treated posts one in front of the other.
b. Bury and cement the posts 4-5’ in the ground.
c. Face the skinner side (~5.5” wide) toward the direction the zip line ride will
travel.
3) Wait 24 hours to let the cement dry.
4) Sand down the edges of the posts to make them more rounded where the zip line cable
will wrap around.
5) Use the post like a tree to continue your zip line installation.
To Next Page
Loading...
Need help?
General