Zip Line Fun ZL90 User Manual

A. Attachtherstclamp(atthehigh
end) so the U-bolt is one clamp
base width from the dead end
of the wire rope.
B. Tighten U-bolt nuts evenly on
rstclamp.Attachsecond
clamp no closer to the
tree/upright than 1½ times
the diameter of the tree/upright.
C. Attach the third clamp evenly
betweenthersttwoclamps.
Now tighten all nuts evenly.
Re-tighten all nuts after
the rst ride.
DISTANCE NOTE: Do not place the
rstcableclampclosesttothetree/upright
any nearer than 1½ times the diameter of the
tree/upright.
A
B
C
INSTALLATION and ASSEMBLY SAFETY INSTRUCTIONS (continued)
Please Note: Observing the following statements and warnings reduces the likelihood of serious or fatal injury.
3. Using three (3) of the cable clamps (B) provided with lockwashers and nuts, secure the cable at the starting point
(high end) as illustrated below. Tighten the nuts carefully with a socket wrench and push the tread caps (F) over the
exposed threads.

Zip Line Fun ZL90 Specifications

General

Brand	Zip Line Fun
Model	ZL90
Category	Accessories
Language	English