Zip IP-CAM360 - Page 10

10
Step B Click on Properties Step C
Click on Internet Protocol Version 4 (TCP/IPV4)
and click Properties
Step D Click on Advanced
Step E Click Add
Step F Add an IP address in the range of the IP cameras but not the IP camera/s itself then click OK
This will allow ZipFinder to access not
only the 192.168.0.? addresses but also
the 192.168.10. ? addresses for changing
to 192.168.0.<n> addresses.
Also ZipFinder uses multicast protocol
for searching across subnets but firewalls
preclude this, so firewall may need to be
disabled during this process.