Zip IP-CAM360 - Remote Settings: Alarm, Device, System, Tools

33
5.3.4 Alarm
5.3.4.1 Motion Detection
Click on Motion in Motion Detection menu.
Enable: Click in box to enable motion detection.
Sensitivity: Set the motion detection sensitivity level ( 1~ 8)
The higher the level the less pixel colour changes needed to record
Alarm Out: Click in box to enable alarm output.
Latch Time: Set the latch time for the alarm trigger (Default = 5 secs)
Post Recording: Set the post recording time for the alarm i.e after alarm triggers.
(Default = 5 secs)
Send Email: Click in box to enable Email (Email settings are required)
Enable Record: Click in box to enable Alarm Record.
Refresh: Applies default settings
Save: Saves Motion Detection settings.
Clear: Clears all motion settings.
All: Sets whole picture for motion detection. (Complete area red colour)