Zipro Wave White - Page 23

23
EN
2. EXERCISE PHASE
This is the exercise proper. Maintain your own pace to reach the heart
rate appropriate for your age as shown in the chart below.
3. RELAXATION PHASE
This phase helps steady the circulation and relax the muscles. It is
identical to the warm-up phase. Remember not to strain your muscles.
TROUBLESHOOTING
CAUTION! Opening the housing of the device without a prior contact with a manufacturer’s service voids the warranty. If you suspect a failure that requires
the housing to be opened, contact manufacturer’s service.
Error description
Possible causes
Solution
The device rocks to sides
The device was placed on an uneven surface.
There is an object disrupting the balance under the base
of the device.
Place the device on an even surface.
Remove the object that upsets the balance.
The bases have not be assembled correctly.
Assembly the bases correctly.
Level the caps on the rear base.
Caps on the base have not been installed and levelled
correctly.
Assembly the rear base correctly.
Level the caps on the rear base.
The saddle or handlebar sway
Bolts and knobs of the saddle column or handlebar
column have not been tightened.
Tighten the bolts and knob of the saddle or handlebar
column.
Noise during use
Incorrectly tightened elements.
Contact the manufacturer’s service.
Slight humming noise may be heard during operation due to the inertial movement of the flywheel caused by the
nature of the structure. It does not affect the operation of the device. Any possible humming noises heard when
rotating the pedals backwards occur for technical reasons and have no negative consequences.
Noise and uneven operation
Bearings damaged.
Contact the manufacturer’s service.
Lack of appropriate
resistance during training
Computer cable connected incorrectly. Connect the cable correctly as per the assembly manual.
Drive belt loose.
Contact the manufacturer’s service.
The distance between the flywheel and
the magnets increased.
Contact the manufacturer’s service.
Voltage regulator damaged.
Contact the manufacturer’s service.
No Bluetooth
connection
Bluetooth connectivity issues.
Enable Bluetooth on your mobile device.
Pair your mobile device with ZIPRO.
---
Grip not work correctly.
Contact the manufacturer’s service.
E-1 The device receives no input while measuring the user's
body fat.
Keep both hands on the pulse sensors during the
measurement.
E-2
Power system error.
Contact the manufacturer's service.
E-4
The numerical scale was exceeded when reporting the
age, height, or weight of a user.
When entering user data, provide data that fit the scale.
E-7
The cables connecting the console to the bike have
become disconnected or are not connected properly.
Disconnect the power source, then disconnect the
cables. Reattach the cables and power source. If the
error occurs again, repeat the process.