Ziton ZP755B-2 - User Manual

© 2014 UTC Fire & Security. All rights reserved. 1 / 4 P/N 501-1771ZE-1-10 • REV 10 • ISS 16APR14
ZP755B-2 Addressable Sensor Base Sounder
Installation Sheet
Description
The ZP755B-2 is an addressable sounder designed for use on
Ziton analogue addressable fire detection and alarm systems.
The sounder includes a volume control, an address-setting
switch, programmable tone settings, and a pair of jumpers to
select the operating power — from the analogue addressable
loop or an external supply. The sounder plugs into a base that
is purchased separately. See Table 1 for a list of model
numbers.
Table 1: Models
Model number Description
Sounder:
ZP755B-2P Addressable sensor base sounder, Polar white
Base:
SPB–2P Plug-in base, Polar white
Installation
To install the device, follow these general steps.
1. Wire the base.
2. Set the operating power.
3. Set the address.
4. Set the mode of operation.
5. Set the tone.
6. Set the volume.
7. Mount the sounder onto the base.
The details of each step are given below.
Wiring the base
Connect the loop wiring for the plug-in base as shown in
Figure 1 below. There is no wiring between the sounder and
plug-in base.
Figure 1: Loop wiring for the plug-in base
1. Ext. 24 VDC+ IN/OUT
2. Ext. 24 VDC ground IN/OUT
5. Loop+ IN/OUT
6. Loop − IN/OUT
7. Shield
Setting the operating power
The sounder includes a pair of power selection jumpers, J1
and J2. To select the source of the sounder operating power,
position the jumpers as show in Figure 2.
Figure 2: Power-selection jumper configuration
1. Loop powered 2. External 24 VDC
Note: When using an external power supply, use only one that
is CE and EN 54-4 compliant to power all the sounders on the
same loop.
6
2
5
1
J1 J1J2 J2
21

Summary

Product Description and Models

Wiring the Base

Setting the Operating Power

Setting the Device Address

Operating Mode Configuration

Device Mode Selection

Tone Settings

Setting the Volume Control

Mounting the Sounder

Sounders per Loop Capacity

Product Specifications

Operating Environment

Specifies the temperature and humidity ranges for operation and storage.

Regulatory Information Summary

Details regulatory compliance and CE marking information for the product.

Certification and Compliance

Lists certification body, performance declaration, and product identification.

European Union Directives

States compliance with R&TTE and WEEE directives for the device.

Contact Information

Provides web address for contact details and further product information.

Ziton ZP755B-2 Specifications

Operating Environment

operating temperature	−10 to +60°C
storage temperature	−20 to +70°C
relative humidity	10 to 95% noncondensing

Power

operating voltage	18 to 30 VDC
external supply	19.5 to 20.5 V pulsed, max. 4 V line loss
quiescent current (line powered)	820 µA
alarm current (line powered)	4.5 mA
alarm current (externally powered)	7.5 mA max.

Sound Output

sound output level	70 dBA
tone 1 frequency	980 Hz continuous
tone 2 frequency	980 Hz intermittent (0.5 sec. on/off)
tone 3 frequency	two-tone warble 980 Hz/670 Hz

Weight and Dimensions

weight	150 g
dimensions (ZP710/ZP730)	127 × 69 mm
dimensions (ZP720)	127 × 90 mm
dimensions (ZP732/ZX732)	127 × 97 mm