ZKTeco EC16 Quick Start Guide

1
2
2
3
3
4
5. Add Expanding Board
Make sure to power off the device and connect the expansion board correctly, then set the RS485
address of the expansion board with the DIP switch and restart the device.
1
2
3
11
3) Select the levels group and then click to move it to the selected column on the right.
c. Set Access By Department
1) Click Elevator > Elevator Control Rule > Set Access By Department to enter the setting interface.
2) Check the department and click the Add to Default Levels icon in its bar to open the settings
window.
4) Click OK to confirm and exit.
1) Click Elevator > Elevator Device > Expanding Board to enter the setting interface.
2) Click New to add a expanding board.
3) Set the relevant parameters and then click OK to confirm and exit.

ZKTeco EC16 Specifications

General

Brand	ZKTeco
Model	EC16
Category	Computer Hardware
Language	English