ZKTeco EC16 Quick Start Guide

8
1. Add the elevator control device on the software
Login to the software and add the device by searching. The process is as follows:
1) Click Elevator > Elevator Device > Device to enter the device setting interface.
2) Click Search to open the Search interface in the software.
3) Click Search to search the elevator controller. After searching, a list of controllers will be displayed.
1
2
3
4
5
6
4) Click Add after the controller in the operation bar to add the device.
5) After setting the relevant parameters, click OK to finish adding the elevator controller.
6) Click Close to close the Device Search Add interface.
2. Register users and send to the elevator control device
1) Click Personnel > Personnel > Person > New to register users in the software.
2) Add users to elevator control level.
3) Click Elevator > Device > Control > Synchronize All Data to Devices to synchronize all data
to the controller, including new users. As shown in the figure below.
1
2
3
Connect to ZKBio CVSecurity

ZKTeco EC16 Specifications

General

Brand	ZKTeco
Model	EC16
Category	Computer Hardware
Language	English