Zline DW-WM-18 Manual

24
Troubleshooting
TROUBLESHOOTING
E1 Longer Inlet Time
Is there any
water in the tub?
NO
Is the incoming water turned on?
Is the water supply line
installed correctly?
NO
Replace the hose.
NO
Unkink drain
hose.
YES
Is the incoming water pressure
20 PSI -145 PSI?
NO
Adjust water pressure
to desired range
of 20 PSI -145 PSI.
YES
Is the drain hose
working properly?
YES
Is the water supply
valve open?
NO
Is the hose blocked
or kinked?
NO
Make sure
water supply valve
is open.
YES
Is the inlet water
supply waterline
installed correctly?
YES
Is the inlet valve
correctly placed?
YES
Reconnect the wire of
flow meter circuit
and check again.
YES
Unkink the hose.
YES
Is the flow meter
circuit correctly installed?
NO
Reconnect the inlet
value circuit wire.
If the problem persists,
replace the inlet.
YES
Is the pressure switch
correctly installed?
NO
Reconnect flow meter
circuit wire.
If the problem persists,
replace the flow
meter.
YES
Reconnect the pressure
switch and check again.
NO
Reconnect the
pressure switch.
If the problem persists,
replace the pressure
switch.
MODELS WITH
PRESSURE SWITCH
MODELS WITH
FLOWMETER
If the problem has not been solved through all the instructions mentioned above, the PCB
might have a malfunction. Replace PCB and test again.

Zline DW-WM-18 Specifications

General

Style	built-in dishwashers
Color	white matte, matte white
Load Capacity	16
Number of Cycles	6
Options/Settings	energy save, quick wash, normal, rinse, eco wash, heavy wash, sanitary, high temperature wash, glass, heat dry option
Drying Type	heated drying
Noise level	40 decibels adjusted
Control Type	touchpad
Delay Start	yes
Number of Racks	2
Sanitize Settings	no
Annual Energy Consumption	234 kilowatt hours
Voltage	120 volts

Weight and Dimensions

Depth	23 inches
Height	32 1/2 inches
Width	17 3/4 inches
Net Weight	73.7 pounds