Need help?Do you have a question about the Zline EMBY-BTF-MB and is the answer not in the manual?
General| Handle Style | Lever |
|---|---|
| Material | Brass |
| Number of Handles | 1 |
| Valve Included | Yes |
| ADA Compliant | Yes |
| Warranty | Limited Lifetime |
| Installation Type | Wall Mount |
Prepare subfloor, mark, pre-drill, and drill holes for water lines.
Position mounting plate and insert long bolts through pre-drilled holes.
Attach gasket, plate, washers, and nuts to secure the base tightly.
Slide the mounting cap over the water lines and onto the base.
Insert brass ring, connect to filler body, and guide unit through hole.
Install short bolts through brass ring and tighten to steel mounting plate.
Adjust spout orientation and then tighten bolts for stability.
Move the mounting cap down to its final resting position.
Connect cold and hot water supply lines securely.
Connect the shower handle and hose to the main filler body.
Turn on water supply lines and operate the water valve lever.
Pull the diverter valve knob to activate the shower handle system.
Details the limited lifetime warranty applicable to ZLINE bath tub fillers.
Defines warranty terms, residential application, and geographic coverage.
Lists specific conditions and items explicitly not covered by the warranty.
To Next Page
