Refer to this table to correct minor issues before calling for service.
ERROR CODES
If there is an air gap installed with your dishwasher, make sure it is clean so the
dishwasher will drain properly. Air gap is not part of your dishwasher. Before you
clean the air gap, turn off the dishwasher, then remove the plastic air gap cover and
clean with a toothpick.
Caution:
• If an overflow occurs, turn off the main water supply before calling for
service.
• If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
CODE MEANING POSSIBLE CAUSE
E1 Slow fill time/fill time has
exceeded time alloted
• Faucet is not opened
• Water intake is restricted
• Water pressure is too low
E4 Overflow A leak in the dishwasher
E8 The orientation of the distributary
valve not working.
The wire is not connected correctly,
or the distributary valve is broken.
E9 A button has been touched
for more than 30 seconds (by
anything, including water).
Anything (including water)
touching a button.
TROUBLESHOOTING
56
Troubleshooting
To Next Page
Loading...
Need help?
General
