Zline MWD-1 - Page 21

16
5. Push the microwave into the slot in the rear bracket by extending the support beam
(Figure 1).
6. Use screw #3 to fix the front bracket and support beam (Figure 2).
Trim Kit Installation
①
②
①
Push the microwave which had install bracket into the slot in the rear bracket by extending the
support beam( picture 1)将预装好的微波炉顺延着支撑横梁推到后支架卡槽内为止（如图一）
② Use 3# screw to fix the front bracket and support beam( picture 2)再用 3#螺丝安装前支架与支撑横
梁对应孔位（如图二）
complete
Picture 1
Picture 2
Figure 1
Figure 2
2
1
INSTALLATION Trim Kit