21
Cleaning the Range
MAINTENANCE AND CLEANING
CLEANING BURNEDON RESIDUE
1. NOTE: It is very important that you DO NOT use the range top until it has been thoroughly
cleaned. WARNING: Damage to the glass surface may occur if you use scrub pads or
any other type of abrasive cleaning materials.
2. Allow the range top to cool.
3. Spread a few drops of the ceramic glass cleaner on the burned residue area.
4. Using the ceramic glass cleaning pad, rub the residue area, applying pressure as needed.
5. If any residue remains, repeat the steps listed above.
6. For additional protection, after all residue has been removed, polish the entire surface
with the ceramic glass cleaner and a paper towel.
CLEANING HEAVY BURNEDON RESIDUE
1. Allow the range top to cool.
2. Carefully use a single edge razor blade scraper approximately at a 45◦ angle against
the glass surface and scrape off the residue.
3. After scraping off the residue, apply a few drops of the ceramic glass cleaner on the
entire burned residue area. Use a cleaning pad to remove any remaining residue.
4. For additional protection, after all residue has been removed, polish the entire surface
with the ceramic glass cleaner and a paper towel.
METAL MARKS AND SCRATCHES
• Be careful not to slide pots or pans across the range top surface. It may leave behind
metal markings. These marks can be removable using a ceramic glass cleaner and
cleaning pad.
• If pots with a thin overlay of aluminum or copper are used, the overlay may leave a
black discoloration on the range top. This should be removed immediately before using
the range top again or the discoloration will become permanent.
• NOTE: If cracks or indentations in the glass surface occur, the range top glass will have
to be replaced. Contact ZLINE at 1-614-777-5004 for assistance.
To Next Page
Loading...
Need help?
General
