23
Changing Doors
MAINTENANCE AND CLEANING
CHANGING DOORS AND KICK PLATES
1. Open oven door and insert metal pins into each door hinge (NOTE: Pins are not
included). Close door half way. Pull up and out on door to remove.
2. Uninstall the kick plate by unscrewing the four screws in the kick plate. There are two at the
top and bottom on each side. Have a helper tilt the range to unscrew the bottom screws.
3. Remove kick plate.
4. Install new kick plate.
5. Reinstall the four previous screws from step 2.
6. Reinstall new oven door by reversing step 1. Place door hinges into slots of hinge base
receivers, keeping the door in half closed position. The door will drop into the receiver
base when proper engagement is achieved.
7. Open door to full open position slowly to verify proper operation. Remove hinge pins.
A replacement door should NEVER have the pins removed until the door is
securely installed in the range’s hinge receivers.
WARNING
Scan to follow along with a video.
To Next Page
Loading...
Need help?
General
