1
IMPORTANT! Before you begin, make sure
that the power to your doorbell is turned
off. Check your circuit breaker for a switch.
Before you begin:
2
Mounting your Greet Pro
Remove your existing doorbell button. Once you’ve
removed your old doorbell, make sure that the two wires
used to connect your doorbell button remain exposed.
The Greet Pro was designed to seamlessly replace a pre-
existing doorbell button with a mechanical doorbell chime.
If you do not have a mechanical doorbell, you must attach
a 20 ohm/10 watt resistor (not included) between the
connected doorbell and one wire from the power source.
Failing to do so will cause permanent damage to your
Greet Pro and your warranty will be voided.
You will need a strong 2.4GHz/5GHz WPA-PSK/WPA2-
PSK WiFi network near your doorbell.
Make sure that your existing doorbell wiring is connected
to a mechanical doorbell chime and a transformer with a
low-voltage of 10VAC-36VAC.
Warning! Do not directly connect the doorbell to the
primary power source (110/120VAC and 220/230/240VAC).
Mounting
2
To Next Page
Loading...