3
Note: Use the provided screws with anchors when mounting on brick,
concrete, or stucco. When mounting on wood or vinyl, you may use the
screws directly without anchors.
Mark and drill the appropriate holes in the wall for the
mounting bracket. Snap the provided level onto the
mounting bracket and align the bracket against the wall
where you would like to install your doorbell. Using the
bracket as a guide, mark the wall with the four
corresponding holes for screws. Remove the mounting
bracket from the wall and detach the provided level. Drill
four holes slightly smaller than the wall anchors using the
provided drill bit.
2
Remove the mounting bracket from Greet Pro. Take your
Greet Pro out of the packaging and slide down to remove
the mounting bracket as shown below:
Slide down
To Next Page
Loading...