Once the bracket is secure, fasten the two wires to the
terminals on the bracket. Ensure each wire is making
contact with the metal plating of each terminal. You can
fasten either wire to either terminal, but make sure that the
wires are not touching each other.
4
Fasten the mounting bracket onto the wall and connect
the wires to the wire terminals. Tap the wall anchors with a
hammer until the anchors are flush against the wall. Using
the Philips tip for the provided screwdriver and the
provided screws, fasten the bracket into place. Make sure
that the two wires from Step 1 are fed through the opening
and exposed.
Attach Greet Pro to the mounting bracket. First, attach the
security screw partially so that it's easier to tighten it when
the Greet Pro is mounted. Fasten the screw to the bottom
as shown below, using the smaller head on the provided
screwdriver. Then mount the Greet Pro onto the mounting
bracket by pushing firmly and sliding downwards.
5
Note: If you are having difficulty sliding Greet Pro onto its mounting
bracket, please loosen the security screws.
4
To Next Page
Loading...