Why does my Zodiac Pool Systems Accessories smell like chlorine?
If you notice a chlorine odor, it's likely due to the presence of excess chloramines (combined chlorine). To resolve this, manually shock the pool.
What to do if the chlorine level is too high in my Zodiac Pool Systems Accessories?
If the chlorine level is too high, the chlorine output might be set too high. To fix this, turn the chlorine output handle to a lower output number.
Why does my Zodiac Pool Systems Accessories cause eye or skin irritation?
Eye and/or skin irritation can occur due to improper water balance. Ensure you balance the water to the recommended levels.
What to do if my Zodiac Pool Systems Accessories causes cloudy water and slimy pool walls?
Cloudy water or slimy walls in your pool can be caused by: * The cartridge needing replacement (if it has been six months since it was installed). Replace the cartridge. * Combined algae and bacteria growth. Brush down the affected walls and follow the directions for shocking.
How to prevent scale formation on Zodiac Pool Systems Accessories?
Scale formation on pool equipment is caused by incorrect pH levels, which causes minerals to come out of solution. Adjust the total alkalinity to 80-120 ppm, and then adjust the pH to within 7.4-7.6.
What to do if there is no flow to the Zodiac Pool Systems Accessories vessel?
If there is no flow to the vessel, it could be due to a dirty filter. One indication of this is if the pressure is 8-10 psi higher than normal. Clean or backwash the filter.
Why is my Zodiac Pool Systems Accessories vessel leaking?
If the vessel is leaking, it could be due to: * A missing or improperly seated O-ring. Make sure the O-ring is secure in the groove on the vessel housing, and not on the cap. * Faulty plumbing. Repair the source of the leak in the plumbing.
Why is there low or no chlorine in my Zodiac Pool Systems Accessories?
If you're experiencing low or no chlorine levels, there are several potential causes: * The chlorine output may be set too low. Try turning the chlorine output handle to a higher output number. * The chlorine dispenser might be low or empty. Refill it with tri-chlor tablets. * For outdoor pools, the stabilizer (cyanuric acid) level in the water could be low. Add stabilizer to maintain a level of 10-50 ppm. * The unit may not be operating for sufficient hours. Increase the system operating time per day. * A temporary loss of chlorine could be due to a heavy organic load (rain, leaves, fertilizer, heavy bather load, or pets). Increase chlorine production and run the pump for 24 hours. Recheck levels and super chlorinate if needed. * New pool water needs to be shocked properly up...
Covers equipment safety, chemical handling, and general operational hazards.
Details dangers related to pressure, chemicals, suction fittings, child drowning, and water temperature.
Specifies where and how the vessel must be installed in the plumbing system.
Step-by-step guide for connecting the vessel into the pool's plumbing system.
Instructions for installing the vessel in a bypass configuration for larger plumbing or higher flow rates.
Guidance for installing the vessel in a split-return configuration with a water feature line system.
Recommended water balance conditions for optimal operation and pool protection.
Steps for installing the start-up cartridge, balancing water, and turning on circulation.
Table listing common problems, their possible causes, and recommended corrective actions for the Nature² Fusion system.
General| Compatibility | Inground pools |
|---|---|
| Chlorine Generation | Yes |
| Capacity | Up to 40, 000 gallons |
| Mineral Cartridge Life | 6 months |
| Type | Mineral Sanitizer and Chlorine Generator |
| Dimensions | Varies by model |
| Technology | Mineral Sanitization |
| Power Supply | 120/240 VAC |
| Warranty | 1 year |
| Replacement Cartridge | Nature2 Fusion Replacement Cartridge |
To Next Page